Exchange Port Expander Module 1U

Expander1UFrontView
Expander1USideView
Expander1UBackView
ExpanderPhoneLogo
EXCHANGE EXPANDER 1U
Expander 1U is an add-on to the Exchange patching module for bringing patch chain signals out to jacks on the front panel. This increases the patching options for an Exchange module or allows access to the chain signals between modules.
 
Expander 1U can be connected to the chain inputs or outputs of the Exchange module. They can be connected at the beginning, middle or end of a chain of Exchange modules. Or they can be chained together to pass 8 signals around the back of your modules to avoid having long patch cables criss-crossing your rig.

IN STOCK

£79.00Add to basket

The 8 jack sockets are connected to the 8 patch chain paths at the module’s rear. There are two connectors, one for the jack signals and one for the jack ‘normal’ signals. Patch chain inputs and outputs are connected using the signal connector. The normal connector allows a set of signals to be passed through into the chain when the corresponding jack is removed (see the block diagram below). Patch chain cables are used with these connectors to connect to the Exchange patch chain. 

Expander can also be used to provide alternative inputs for the Preset and Reset input ports of Exchange, freeing up Exchange inputs 7 and 8 for use as regular patching inputs.

Exchange Expander 1U ships with one 20cm patch chain cable. Additional cables can be purchased separately here.

Features

  • 8 jack sockets usable as normalled inputs OR 8 outputs
  • 8 chain normal and 8 chain signal connections (on module rear)

Specifications 

  • Width: 12HP
  • Height: 1U (Intellijel)
  • Depth: 21mm (including chain terminator)
  • Current: passive, no power consumption
  • Assembly: fully assembled and tested
Expander Architecture
Shopping Basket
Scroll to Top